You can download the demo...

The developer is very good about responding to Emails...

Never mind.
Just found the UType unit in another directory.
-Thanks.

using the google translate, I can not figure out where you pass the pin assigned from the GUI to the DLL. (i.e. x,x_dir,y,y_dir,,a,a_dir,b,b_dir,enebale etc...)
-D

Jerome,
I am not sure anyone other then you can do it at this time.
Perhaps in the future when detailed interface documentation are available (in English) other might jump in.
Right now, I can not find out what parameters the program passed to the DLL and what 'services' the program requests from ...

Jerome,

1) Yes I am sure I put the the new DLL in that directory and slected it. (I renamed the old one to cncnet_xp_old.dll and it showed in the gui menu as cncnet_xp_old.dll)
2) Did you try the Parmon utility on your computer ? On my machine it does not look like you are stetting the motor enable ...

the signal is has not changed ... :(

Also you can see with this utility http://www.geekhideout.com/parmon.shtml

I now know that pin one (1) needs to be high (and not low as I thought).

I defined Engine on/off as pin 1 in the GUI but according to Parmon software nothing change.... (When Mach3 ...

Where does one find the doc describing the DLL requirements and in/out interfaces ?
Is there such a doc ?
source code with English comments ?

No,no,no. You got it wrong.

The idea is not to go to G-code but rather just use the March3 stepper motor interface DLL and setup file. (polarity,speed,step, direction etc..)

This will be a direct replacement to the existing Machine DLL....

-D

Development idea :

Background : There is an explosion of new low cost CNC controller boards coming from all over the world (mostly from china)

Problem: Many times it is a real challenge making them work with Jedicut.

Solution:
1) Every new 4 axis controller board comes with instructions of ...

I tried all the dll's and none works.

The only DLL that seems to ' almost ' work is the CncNet_win_XP_Vista bit it gets an error popup... see attached file.

When I tell it to do a long movement with the CncNet_win_XP_Vista, ignore the popup error and then use the parallel port monitor and toggle ...