Allways check "Cutting Wizard" before cutting!
Wire radiation you can account in "Skin property". In your example 0,5 mm (30-29/2).

I think that You do some mistake in "Cutting Wizard" (Taglio wizard).

Hello!

I like this idea.(tu)

Currently Jedicut goes inversely than Complexes.
Clockwise in Complexes - anticlockwise in Jedicut.
It would be great to sync "the clocks".

[quote=Jerome]
Jedicut should open profiles corresponding to "Emplature" and "Saumon" part, nothing else ?

Is it right ?

It's more easy to do that than convert CPX to JDC. :S[/quote]

I did not want to admit that I do not understand what it means "Emplature" and "Saumon" but I must ask.
Does it ...

[quote=Jerome]
Do you try to move foam to the extrem left of the table, near motors (or to the extrem right) ?[/quote]

Yes, this is the best thing I can do. But it is bit too little.

[quote=Jerome]
It's more easy to do that than convert CPX to JDC. :S[/quote]
Life is not easy.:)-D

I have problem with profiles where tip and root are diferent or have different chords.
Cutting wizzard does strange cutting lines sometimes.
In Complexes I can set start point and equal number of ...

Hi Jerome
My question was half-baked.
I want to make sure, your algorithm uses max cut speed on the side where is more steps to do.
Eg. Jedicut sends sequentialy 10 steps on X1 side and 1 step on X2 side - max speed on X1 side and 10% on X2 side.

In addition I have a little problem with Cut ...

[quote=Jerome]
The main difficulty is to find time to do it...[/quote]

I uderstand you.

[quote=Jerome]
Are you also interested by this plugin ?[/quote]

Yes, I have problem with more complex shapes.

Hi Jerome
I set cut speed but I don't know for what point of wire it is calculated: X1, Root, Tip, X2 or another.
It is important when root and tip chord are significantly different.
Can you explain the problem?

Thanks, ronys. Complexes is very useful program.
Jerome, can you realy prepare a plugin which convert CPX to jdc?