actually I'm working with S4Cut from StepFour.
This is a really nasty DOS-based application and I need to get rid of it.
For this I'm searching for a new Software which should work on WinXP or higher.
My Hardware is this here:
http://shop.strato.de/epages/61125483.s ... SM44PCV5.2
It's controlled over parallel port.
I'm looking for a software, where I could load dxf files, define cutting-settings and directly cut on my machine.
Could Jedicut do this job ? Or do I need any additional software ?
Perhaps there is a german manual available for jedicut or at least an english?
- La découpe CNC
- - Jedicut - Forum Français
- - Electronique
- - Mécanique et table de découpe
- - Vos réalisations CNC
- - Plugins pour Jedicut
- English board
- - Jedicut - English board
- Les autres forums
- - Les sites des aéromodélistes
- - Petites annonces entre modélistes
- Les forums des blogs de Aeropassion
- - Aero 2009
- - AeroMicro