I made this control board, http://kitsrus.com/pdf/k179.pdf,
but does not work with Jedicut,
how do i connect it?
thanks

Hello Rui,
You must connect the "step" and "dir" pins of your interface with a parallel port, and configure Jedicut to obtain the correct assignation of the pins "step" and "dir".

For example, connect the "step" on the pin 2 of the parallel port, and "dir" on the 3rd pin.

Launch Jedicut, go to "tools", "options", "communication", and select correct pins assignment : 2 for the step, and 3 for the direction.
Your motor should turn if you send an order in manual control.

Thanks for your help.
I've done all this but the engine just tremble, do not rotate.
With the software CENECE the engines spin well,
I have tried all settings available in the JEDICUT, dll's, and nothing works.
Can you help more?

hello,
ok, so you may try to increase the cut speed and fast speed values in "options", tools", CNC controller.

for example, try this :

nb mm.pas : 0,020780
cut speed : 30000000
fast speed : 15000000

(modify for all axis of course)