Hello my friends,
Last week my windows XP computer and as well my cnc controller have been broken because of a power issue.
Now I have the problem that I need to buy ore to use a other computer without LPT.
And to build ore to buy a new cnc controller.
As you know the new computers have rather LPT port as well laptops.
I have read as well about the solution with the adruino board USB to LPT.
Never the less I was looking around for a usb 4 axis cnc controller.
I have found more as 1 board in China with red an blue TB6560 pcb.
Does there exist a usb cnc controller what woks with jedicut out of the box?

Best regards,

Wolf

Hi and welcome !

Unfortunately there is no usb controller available out of the box :/

You can take a look at Aeroden usb controller built with arduino. He did an amazing job

Here on this side

https://www.jedicut.com/en/

This image is a MDLCNC board.
https://www.jedicut.com/en/wp-content/u ... 44704k.jpg

What kind of USB interface is that...? Where to get that that...?

Wolf

Hello !

It's a parallel port to usb convertor build with an arduino uno. You can find all things you have to know to build it on this website