Is there a way to set the parallel pin for heat control in CncNet_XP.dll. I use a PCB of HobbyCNC.
http://www.hobbycnc.com/products/auto-h ... board-kit/
Thanks
Re: Heat parallel control
3OK!
The questin is: on my pcb AHATB of HobbyCNC i have:
pin 10=timer
pin 11=heat feadback
pin 12=auto/manual heat control
pin 16= heat.
How can i set Jedicut for the pin of mY board???
The questin is: on my pcb AHATB of HobbyCNC i have:
pin 10=timer
pin 11=heat feadback
pin 12=auto/manual heat control
pin 16= heat.
How can i set Jedicut for the pin of mY board???
Re: Heat parallel control
4Hi,
It's the same pin configuration on MM2001 board. Jedicut will control wire heating
It's the same pin configuration on MM2001 board. Jedicut will control wire heating
Jerome
Re: Heat parallel control
5Thank you!
All OK.
But i have another question.
Is there a way to set wire radiation in Jedicut?
All OK.
But i have another question.
Is there a way to set wire radiation in Jedicut?
Re: Heat parallel control
7Yes thank you!
I can performe some test before cuttin.
Another question:
How can i convert .cnc file (GMFC) for use with Jedicut?
I can performe some test before cuttin.
Another question:
How can i convert .cnc file (GMFC) for use with Jedicut?
Re: Heat parallel control
8Hi,
I think someone explain this on this board but I don't remember when, and I don't fin the message... I'm searching...
I think someone explain this on this board but I don't remember when, and I don't fin the message... I'm searching...
Jerome