Hello,

I have got inquiry as to cutting two different profiles. My longitude wire is 1200mm plus uncut sheet about to be long only 232mm.
Root profile about to be 80.4mm and Tip profile 53.2mm.I set cut wizard, but always it goes every otherwise.
I would like ask according to what designates placing and number key point?

thank you very much and sorry for my english

Hello,

When you cut un wing, you have to start the cutting of root and tip profiles at the same time, and you have to finish the cutting at the same time too. Jedicut calculate this without problem.

Some times, you need to force Jedicut to synchronize the cutting some where on the profiles. These synchronization points is called KeyPoint in Jedicut.

For example, you need KeyPoint when you want to cut ribs but in this case Jedicut automaticaly add it but you don't see it You can add your own KeyPoint everywhere on your profiles.