Hi there,

I`m trying to use jedicut with my 3D-Step card - but none of the dll`s with customized parameters does work.
Where do i get a .dll for my card? I used google a lot, but it seems like, i`m the only one with such problems.

Any hints?

greets, Nik

hello nik, what-is 3d-step-card ??
where do you find-it?
hugo

Hi,

http://www.nc-step.de/step3d-e.html

(i got it with 4 channels.)

here is some documentation:

http://www.nc-step.de/pdf/3dstep_doku_27_en.pdf

greets, Nik

Hi,

You can try. If Jedicut don't work with your card, you can program your own dll following this tutorial :
http://www.aeropassion.net/leblog/pages ... un-plug-in

o

Dear Jerome,
is the tutorial also in english available?
Best regards
Frank

Hi !

Are you interested in programming a new Jedicut add-ons ?

I will translate this page in the next weeks. I'm looking at Google code to publish Jedicut's dll source files, maybe under LGPL licence.

Programming isn´t my profession. I would like to try to make a dll which support exact my board with the Alegro A3977SED stepper driver.
The specification of the signal is on the following link: http://www.datasheetcatalog.org/datashe ... s/3977.pdf on page 8. Is it possible to built the dll?
Frank