Hallo,

whwn i will Start Jedicut under Win-7, i become
the Message in the Attach.

have anyone a Idee, where the Problem come?

Thank's, MAES

Do you have this problem every time you launch jedicut? I have been a once and nothing since. I use w7 32

This Error come every time.

When i push "ok"(4 or 5 times), Jedicut run, but cannot configure.
When i take any Hardware .dll, the Error come.
I use Win-7/64 without LPT.(Notebook)
For Jedicut i will use the Xavier-USB as Hardware.

Try to excecute Jedicut with W xp sp3 compatibility

[quote=vercomax]
Try to excecute Jedicut with W xp sp3 compatibility[/quote]

I try it so, is the same Probleme

Hallo,

i have found the Problem.
Show here: http://www.aeropassion.net/forums/read.php?19,4548

Hello,
Can you resume your solution ?
Files were not in the right directory ? Or you don't delete uncompatible dll in Jedicut's directory ?

Hello (and have a happy christmas

IO.sys doesn't work with win 7.

You should install the newest version of Jedicut which normally doesn't install the IO.sys if win 7 is used.

Hello (and have a happy christmas)

I have replaced from the Jedicut-directory: io.dll
My Win7 Notebook have no LPT-Port.
I have replaced from the Jedicut-directory\dll: CncNet_XP.dll, CncNet98.dll, MaxCom.dll, MaxCom_XP.dll,
MDLCNC_XP.dll, VisualCNC.dll, VisualCNC_XP.dll.

Manfred